Field Service Ver. 1.0 Aug. 2005 6. Firmware upgrade
43
bizhub 200/250/350Maintenance
NOTE
• Be sure to turn ON the sub power switch first before turning ON the main power
switch.
4. Turn ON the main power switch.
5. The firmware upgrading sequence
will start.
6. When the upgrading sequence is
completed, which is notified by the
message “FINISH” appearing on the
screen, turn OFF the main power
switch.
NOTE
• NEVER turn OFF the main power
switch until the message “FINISH”
appears on the screen.
7. Remove the Compact Flash [2] card
from the slot.
8. Turn ON the main power switch.
9. Call the Tech. Rep. Mode to the screen.
☞ 148
10. Select [ROM Version].
11. Make sure if the version of Firmware is updated.
4040F2C749DA
4040F2C597DA
[2]
To Next Page
Loading...
