ETC Hog 4 PC - Removing Values

176 Hog 4 Operations Manual
6.5 Removing Values
As well as assigning values for parameters, you will sometimes want to remove parameter
values from editors. For example:
•
You no longer want to use a particular fixture in a cue, scene or palette.
•
You decide to have the colour of several fixtures controlled by a different cuelist on
another playback. To do this, you need to remove colour parameter values, so that they
don't take over control of the colour parameters under the LTP rule. See HTP and LTP.
Tip: If you want to clear the entire contents of an editor, use the Clea r key.
6.5.1 Removing Entire Fixtures from an Editor
To remove selected fixtures from an editor (known as ‘knocking out’), press the Knockout
button on the Main Toolbar. For example:
•
Fixture 1 Th ru 5 Knocko ut : removes Fixtures 1 to 5 from the editor.
•
Group 2 Kn ockou t : removes all fixtures in Group 2 from the editor.
6.5.2 Removing Kinds from an Editor
You can remove specific parameter types from the selected fixtures in an editor using fixed
kinds or user kinds keys:
•
Colour , Knocko ut : Select the parameter type and press Knockou t
6.5.3 Removing Individual Parameters from an Editor
You can remove individual parameters from the selected fixtures in an editor:
•
Hold Knockout and move the relevant parameter wheel, or press the relevant button
on the Slot To olbar.
•
Hold Backsp ace and move the relevant parameter wheel.
•
Hold Backsp ace and press the relevant parameter type key; this gives single-handed
operation.
•
You can remove the values from the currently highlighted cells in the Programmer by
pressing Pig + Backspace.