240 Hog 4 Operations Manual
12.1 Recording Scenes
You can record scenes either directly to a physical master for immediate playback, or to the
Scene Directory.
12.1.1 Recording to the Scene Directory
To record a scene:
1. Create the look for the scene in the Programmer or editor.
2. Re cord, Scene : the Scen e Director y window opens.
3. Select the destination location in the Scene Directory window.
4. Alternatively, enter a number on the keypad and press Enter.
12.1.2 Recording to a Physical Master
You can record a scene directly to a physical master. Hog 4 OS will automatically put it in the
next available location in the Scene Directory:
1. Create the look for the scene in the Programmer or editor.
2. Re cord, Sce ne
3. Press the Ch oose key above the desired physical master.
12.1.3 Naming a Scene
You can give a scene a name that will be displayed in the Scene Directory window:
1. Open + Scene : open the Sce ne Directory.
2. Check that the G ua rd button is selected, so that you don't accidentally activate a
scene when pressing its button in the directory.
3. Select the scene.
4. Set [ n a m e ] En ter : type in the name.
Tip: To name a scene immediately after recording it, pressing the Set key will open a
Quickname window. Enter the scene name and select O K.
.
12.2 Deleting Scenes
To delete a scene:
1. Scen e 1 De lete
2. Click OK to confirm the delete.
Tip: If you prefer not to be asked to confirm the delete action, select Don't Ask Me Aga in
in the confirmation window. You can re-enable the confirmation by going to Setup →
Prefe ren ces → Progra mming and selecting Confirm before de leting dire ctory
items.
You can delete a range of scenes:
1. Scen e 1 Thru 4 Delete : deletes scenes 1 to 4.
2. Click OK to confirm the delete.
Tip: To detach a scene from its master rather than deleting it completely, hold Delete while
pressing the master's Ch oose button. This removes the scene from the master but not
from the scene directory.
To Next Page
Loading...
