26. Reporting 431
26.2 Organizing and Saving Report Results
By default the results of a report are aggregated and sorted by container (list/scene) and then
further sorted by location, fixture, and function/value. However, you can custom sort, sub-
sort, and sub-aggregate the results as you wish. To master sort and master aggregate the
report results right click on any one of the column headers and select Sort. You can add
other column headers into your master sort & aggregation by right clicking on a column
header and selecting Sub-Agg reg ate. For example, you can sort and aggregate the
reporting results by container and then sub-aggregate by location so that each aggregate
header encapsulates data reported for each cue in a list (e.g. List 1 - Cue 1).
Once a report is run and the data is organized to your liking you can export the results as a
CSV file or a PDF document by pressing the corresponding button in the report window. A file
browser will pop up allowing you to select a storage location for the saved report.
26.3 Using Report Results to Edit Programming
Clicking on any “location” cell in the report results will open that location inside of an editor.
This allows users to view the data in the original editor, make changes, and update the look if
necessary.
Tip: Function values cannot be edited directly in the report results sheet. You must first
click on the location cell to open the data in an editor.
To Next Page
Loading...
