182 Hog 4 Operations Manual
To copy parameter values from the fixtures of one group to the fixtures of another group
within an editor:
Group 1 Copy Fixture Grou p 2 Enter : copies the parameter values of the fixtures
in group 1 to the fixtures in group 2.
Similarly with masking options:
Group 1 Inte nsity Co py Fixtur e Group 2 Enter : copies the intensity values of
the fixtures in group 1 to the fixtures in group 2.
7.8 Insert, Merge and Replace
When recording or copying a group, if the destination location already has a group recorded in
it, you will be prompted with record options of Insert, Merge or Replace.
If you are moving a group, only the Insert option is available.
Insert: creates a new destination group. The new group will be assigned a free location
just before the one chosen, using a point number if necessary.
Merge: Incorporates the new information into the destination group.
Replace: Overwrites the group information in that destination.
Tip: If you know that you are about to record, copy or move a group to an existing
destination, you can pre-select Insert, Merge or Replace from the Record Options Toolbar.
This appears after you press the Record, Copy or Move keys.
To Next Page
Loading...
