454 Hog 4 Operations Manual
28.1 Connectivity Overview
In addition to Art-Net, sACN, and DMX, Hog 4 OS consoles can control visualizers through a
direct visualizer stream via the console's FixtureNet port. For most applications this requires
installation of the Hog 4 Connectivity Driver on the visualization computer. Installation of the
Hog Connectivity Driver is NOT required if running the Capture v2019 (or newer) application
or a Capture v2019 (or newer) presentation file since CITP is supported for Hog visualizer
streaming.
This section describes how to install the Hog 4 Connectivity application on your visualizer
computer, how to physically connect the console to the visualizer PC, and how to configure
both the visualizer PC and Console to enable direct Hog Visualizer Connectivity.
Visualizer applications that support direct Hog Visualizer streaming:
Capture: www.capture.se
L8: l8.ltd
Light Converse: www.lightconverse.eu
Martin Show Designer: www.lighthouse.nl
Vectorworks Vision: www.vectorworks.net/vision
WYSIWYG/Cast: www.cast-soft.com
For visualizer product information, software licensing, and instructions on visualizer
operation, please contact the visualizer manufacturer directly.
To Next Page
Loading...
