29. Updating Software 469
29.2 Console Software Full Install
Occasionally the entire contents of the hard drive will need to be replaced, this is referred to
as a "full install." As the name implies, performing a full install with completely erase the
contents of the hard drive. The Hog OS core operating system will be replaced and any saved
show files will be lost. The requirement for a full install will be clearly stated in the release
notes and the fpspkg file will not be available. In some cases a full install may be advised by
support staff to get to a known starting point or to restore console functionality.
Important: Ensure that all show data is backed up. A Full Install erases all data on the
console's hard drive.
To perform a full install:
1. Ensure that all show data is backed up onto an external media device. See Backing Up
Your Show.
2. Power OFF the console.
3. Download the latest Full Install file from the High End Systems website.
4. Create a Full Install USB flash drive.
Refer to Create a USB Flash Drive for full install of Hog 4 OS v3.9.0 for
instructions.
5. Insert the Full Install USB flash drive into one of the USB ports on the console. Do not
use the USB ports located in the front drawer of Hog 4-18.
6. Connect an external USB keyboard to the console. The built-in keyboard on the Hog 4
can be used.
7. Power ON the console.
8. Wait for the “System Installation” screen to appear.
9. To begin the installation process press Ente r on the external USB keyboard.
-Or- use the touchscreen or trackball to click the Continu e button.
-Or- use the Enter key on the console's front panel if the Blind key is
flashing.
10. The installation will now take several minutes to complete.
11. When the installation procedure is complete a "console installation complete" message
will appear.
12. Remove the Full Install USB flash drive from the console.
13. Press the Enter key on the external USB keyboard.
-Or- use the touchscreen or trackball to click the Continu e button.
-Or- use the Enter key on the console's front panel if the Blind key is
flashing.
14. The console will now reboot and the newly installed software will now run.
To Next Page
Loading...
