31. Cheatsheets 497
31.3 DMX Processor Front Panel Button Combinations
The keys on the front panel of the DMX Processor 8000 are used for standard menu
navigation. However as the unit boots you can view specific boot information via a scroll bar.
Once the DMX Processor 8000 is fully booted, it displays the standard menu. In addition the
following reset options are available:
Hard Reset: to force a hard reset of the DMX Processor 8000, hold the middle and bottom
buttons for four seconds (use the center and right buttons for older DMX Processor units
where the front panel buttons are laid out horizontally). Once the reset begins you will see I/O
Board Disconnecte d on the display.
DMX Board Firmware Reload: to reload the DMX board firmware from the Processor's
front panel, hold down any single button the DMX Processor front panel as the unit is
powered on. Once the process begins you will see the DP8000 Bo otlo ade r message on
the display. After about one minute the firmware will be reloaded.
CPU Board Firmware Reload and Restore to Defaults: to reload the CPU board
firmware hold down all three buttons on the front of the DMX Processor as the unit is powered
on. The DMX Processor 8000 will then reload its firmware from the network. Once the
process begins you will see the Forcing Softwa re Reload message on the display.
To Next Page
Loading...
