510 Hog 4 Operations Manual
33.1 Replacing the Screens
Caution: Always shut down and disconnect the mains power before removing the front
panel.
Damaged screens are easily replaced:
1. With the LCD box in the horizontal (flat) position undo the six screws surrounding the
screen using a 3mm allen key.
2. Carefully remove the front metal work and Soft Key strips (soft key strips are on Hog 4
Console Only).
3. With the LCD box in the vertical (upright) position undo the eight screws on the back
panel of the screen assembly using a 3mm allen key. Remove the back panel metal
work. (This entire step for Hog 4 Console Only)
4. With the back panel removed carefully remove the eight screws on the back of the LCD
assembly using a 3mm allen key. Make sure you have somebody hold the screens from
the front of the console while you do this. (This entire step is for Hog 4 Console Only)
5. Lift the screens from the console and unplug the cables from behind.
6. Replace with a new screen assembly by performing previous steps in reverse.
To Next Page
Loading...
