25. Direct Control of DMX Channels 427
25.3 Setting DMX Channels to External Art-Net Source
Hog 4 OS supports routing Art-Net Input from external sources on the Fixture Net network to
DMX Processor Outputs. Hog 4 OS does not support DMX In for console control or signal
routing.
To set a DMX channel or group of DMX channels to values based on a remote Art-Net source:
1. Open the DMX Output window (press the Setup key on the front panel and select the
DMX button on the main toolbar.)
2. Use the drop down menus at the top of the DMX Output window to select a processor
and universe.
3. Select the desired DMX channel cell in the spreadsheet (or highlight a group of DMX
channel cells)
4. Press the Set to ArtNet Inp ut button in the top (the value will now be displayed in red)
5. Open the Network Window
6. Select the corresponding processor and press the Se ttings button.
7. Select the In put tab of the Processor Settings Window.
8. Press the Add Mapping button.
9. Use the scroll boxes to select a range of universe for which you want to configure Art-
Net Input. Press OK.
10. It is important to note that a universe can only have one Art-Net Input mapping per
processor.
11. Modify the port value (incoming Art-Net Sub/Uni) for each mapping as needed.
12. Press Ap ply or OK.
13. The processor will now route the incoming Art-Net stream to the universe and output to
the channels set to Art-Net input in the DMX window.
Caution: Do not configure a processor's Art-Net input and output settings for a given
universe to the same Art-Net subnet/universe.
To Next Page
Loading...
