16. Advanced Programming 299
16.5.2 Blind
Blind mode allows you to continue programming and editing cues, groups, palettes and
scenes without changing the onstage parameter values of fixtures. The Blind key is located
above the Trackball; when in blind mode, the Blind key will illuminate.
Note that when you turn off blind mode all parameter values that you have changed in the
Programmer or editor will instantly appear on stage.
To exit blind mode gracefully, hold down the Pig key while pressing Blin d; parameters will
fade to their new values in the assigned or default fade time. Alternatively, select Fad e
Cha ng es in the editor you are using prior to turning blind on or off.
Tip:Using Pig + Blin d on Hog 4 OS is equivalent to using the Try Cue key on the
Wholehog II.
To Next Page
Loading...
