ETC Hog 4 PC - 23. Linear Time Code

402 Hog 4 Operations Manual
Key OSC Command Path
0 / hog / hardware / zero
1 / hog / hardware / one
2 / hog / hardware / two
3 / hog / hardware / three
4 / hog / hardware / four
5 / hog / hardware / five
6 / hog / hardware / six
7 / hog / hardware / seven
8 / hog / hardware / eight
9 / hog / hardware / nine
A data value of 1 = Key Press On
A data value of 0 = Key Press Off
22.4.4 OSC Fader and Encoder Mappings
Hog 4 OS uses the OSC paths listed in the table below for receiving fader and encoder
commands.
Front Panel Fader/Encoder Incoming OSC Command Path Data
Trackball POS Mode / hog / hardware / posmode
0= toggle off
1 = toggle on
Trackball Position / hog / hardware / trackball X,Y values
Grand Master Fader / hog / hardware / fader / 0 0 < 255 fader value
Main Encoder Wheels / hog / hardware / encoderwheel / # -20 < 20 variable value
Rate Wheel / hog / hardware / ratewheel -20 < 20 variable value
i-Wheel / hog / hardware / iwheel -20 < 20 variable value