ETC Hog 4 PC - Page 420

24. Macros 417
Enable and Disable MIDI Note and Controller Message Input / Output
Comment Macro Syntax Example
Enable Notes In E N I [ n o d e t y p e ] [ n e t n u m b e r ] / [ in d e x ] E N I h 1 / 1
Disable Notes In D N I [ n o d e t y p e ] [ n e t n u m b e r ] / [ in d e x ] D N I h 1 / 1
Enable Notes Out E N O [ n o d e t y p e ] [ n e t n u m b e r ] / [ i n d e x ] E N O h 1 / 1
Disable Notes Out D N O [ n o d e t y p e ] [ n e t n u m b e r ] / [ i n d e x ] D N O h 1 / 1
Controlling Network Devices
Comment
Macro
Syntax Example Notes
Reset
Node
[ n o d e t y p e ]
[ n e t
n u mb e r ]
R N H 3
Resets the selected network device. For the device type,
use the following letter codes: H for Wholehog, D for
processor .
Controlling Keystroke Macros
Macro Syntax Example Notes
GK G K [ ma c r o n u mb e r ] G K 2 Runs Macro 2
HK H K [ m a c r o n u m b e r ] H K 2 Pauses Macro 2
RK R K [ m a c r o n u m b e r ] R K 2 Stops Macro 2
Tip: You can display and select from a list of available macro commands on the console by
selecting the Macr o cell and pressing the Se t key.
24.2.1 Entering Comment Macro Commands
To enter a comment macro command into a macro cell:
1. Select the macro cell, and press Set.
2. Select a command from the drop down menu.
3. Enter the specific information for the macro, such as the master number.
4. Press Enter to finish or select another macro and repeat. If you add a further macro
command, the ‘:’ will be entered automatically.
Alternatively:
1. Select the macro cell, and press Set.
2. Enter the macro command manually using the keyboard.
3. Press Enter to finish.
Note that if you enter an invalid command, then the cell will revert to being empty when you
press Enter .