82 Hog 4 Operations Manual
From these configurations menus you can configure the FixtureNet's IP address (source
address) in one of two ways:
Obtain an IP address using DHCP: select this option when running the Art-Net side
of the console on a network that contains a DHCP server such as a DHCP router.
When using DHCP, the IP Add ress, Netmask, and Gate way fields will be grayed
out. The information contained with them is not relevant to the DHCP configuration.
Use Custom IP Settings: This option allows you to specify the IP address and subnet
mask settings of the FixtureNet adapter. This option is most commonly used on
networks where a DHCP server is not present. Once selected you will need to enter the
IP Address, Netmask, and Gateway for this device on the network.
Important: If you select Obtain an IP address using DHCP on the console and no DHCP
server is present on the FixtureNet network then the FixtureNet adapter will revert to a
loopback address of 127.0.0.1.
3.4.3 Configuring Art-Net Output
Art-Net output is configured using the Outputs tab of the Processor Settings window.
1. Setu p → Ne twork : open the Ne twork window.
2. Select a processor and press Se ttings.
3. Select the Output pane of the Processor Se ttings window.
4. Press the Add Mapping(s) button.
5. Use the Add Mapping(s) dialogue pop-up dialogue to specify a universe range to map,
enable the Art-Net option, and press Ok.
6. An ArtNet output mapping entry will be added to the table with following configurable
properties:
Destination: configure ArtNet output destination to Broadcast or enter an IP
address for unicast.
Port: configure the Art-Net output subnet (0-15) and universe (0<15) or single
combined decimal value.
Changes Only: check this box to transmit only changes to Art-Net data.
7. Once the ArtNet mapping is configured to your liking press okay or apply to confirm the
changes.
To Next Page
Loading...
