CONTROLS
1001 DFB
Drilling & Sawing Line
c6 Continuous execution push-button
Active in the hold (5) or in the standby (3) mode. It selects the
execution of the program in continue mode (line after line without
interruptions till the end of the program). During the execution and
till the end of program the spindle rotation (if present) is kept
active.
c7 Axes movement in jog + push-button
c8 Axes movement in jog - push-button
Active when the machine is in manual execution mode; it is
necessary to select the execution page and the axis to be moved;
pressing + and – keys on the CNC keyboard (b) causes the axis
movement at the speed set with the feedrate.
c9 Hold push-button
Active in automatic execution (1) mode; when pressed axes stop
and if a drilling (marking if present) cycle is under way, it is
interrupted if in a position to be interrupted, otherwise it is
completed; the machine goes into the hold (5) state, the program in
process is interrupted and the reset (passage to automatic execution
mode) is possible pressing the cycle activation push-button. If the
cycle has been interrupted it restarts from the beginning.
c10 Start cycle (CYS) push-button
It causes the start of execution or the restart of an executable
program and sets the machine in single or continuous execution
according to the selected push-button : step by step execution if the
push-button is pressed or continuous execution if the push-button is
pressed. The command is active only when the machine is in hold
(5) state.
To Next Page
Loading...