CONTROLS
1001 DFB
Drilling & Sawing Line
select continuous / single execution mode and then press the
start (b16) push-button
if the message has forced the machine into hold state:
just press the start (b16) push-button.
c25 CONT (CONTINUE)
Push button to continue the input operations.
Active (flashing) when the operation in progress is discontinued.
Example: You are allowed to continue the discontinued drilling
operation by depressing the drill emergency push button.
c26 Push button to operate the VICE opening.
Repetition of this control causes the continuous opening of the
vice. Disactivated with VICE reaching the max. opening limit
switch
c27 Push button to operate the VICE closing.
Repetition of this control causes the continuous closing of the vice.
Disactivated with VICE reaching the max. closing limit switch
c28 Push button to control the carriage pincher opening/closing
c29 Push button to control the carriage pincher lowering
c30 Push button to control the carriage pincher lifting
To Next Page
Loading...