Fuji Electric ALPHA5 Smart - Edit Permission Response: Sequence Output Signal (Reference Value 29); Servo Control Ready [S-RDY]: Sequence Output Signal (Reference Value 28)

CHAPTER 2 WIRING
Description of I/O Signals 2-75
2
Servo control ready [S-RDY]: Sequence output signal (Reference value 28)
Use the signal to check that the servo amplifier and servomotor operate correctly.
 Function
The servo control ready signal remains turned on while the conditions listed in the table below are
satisfied.
Signal
division
Signal name
Function
No.
Signal status
Forced stop [EMG] 10 ON
CONT input
Free-run 54 OFF
OUT output
Alarm detection (Normally
open contact)
16 OFF
The internal CPU operates correctly. -
The L1, L2 and L3 terminals are turned on. -
 Parameter setting
To assign servo control ready to a sequence output terminal, specify the corresponding value
("28") to the output terminal function setting parameter.
Edit permission response: Sequence output signal (Reference value 29)
The signal is output if the "edit permission" input signal for enabling editing operation for parameters,
etc. is turned on.
 Function
After the edit permission assigned to a CONT input signal is on, under some conditions, the "edit
permission response command" is turned on. The conditions are listed in the table below.
Edit permission PA2_74
Parameter change
operation
Edit permission
response
Not assigned 0: Write enable ON Possible
OFF 0: Write enable OFF Impossible
ON 0: Write enable ON Possible
Not assigned 1: Write protect OFF Impossible
OFF 1: Write protect OFF Impossible
ON 1: Write protect OFF Impossible
 Parameter setting
To assign edit permission response to a sequence output terminal, specify the corresponding
value ("29") to the output terminal function setting parameter.