CHAPTER 6 KEYPAD
Sequence Mode 6-9
6
6.3 Sequence Mode
In the sequence mode, the state of the servo amplifier and amplifier setting are displayed.
Press the [MODE/ESC] key until [
Sn01] is displayed, and press and hold the [SET/SHIFT] key for at
least one second to show data.
Key notation
In this chapter, keypad keys may be simply described as shown below.
[MODE/ESC] key
When using as a [MODE] key: MODE
When using as an [ESC] key: ESC
[SET/SHIFT] key
When using as a [SET] key: SET (for at least one second)
When using as a [SHIFT] key: SHIFT
(1) Sequence mode
The status of the output signal of the servo amplifier and operation status are displayed.
ESC SET (1 sec. or over)
Sn01： Sequence mode
Sn02： Amplifier setting
Sn03： Motor setting
Zero speed
Speed coincidence
Ready
-PoF
-
-
Sn01
~PoF
To Next Page
Loading...