Fuji Electric ALPHA5 Smart - 6.7 Parameter Edit Mode

CHAPTER 6 KEYPAD
Parameter Edit Mode 6-33
6
6.7 Parameter Edit Mode
Parameters can be edited in the parameter edit mode.
Press the [MODE/ESC] key until [
PA01] is displayed and press and hold the [SET/SHIFT] key for at
least one second to select parameter editing.
After selecting parameter editing, press the [] or [] key to select the number of the desired parameter
to be edited.
Press and hold the [SET/SHIFT] key for at least one second to edit the data.
(1) Parameter page 1
On parameter page 1, relatively frequently used
parameters are registered. Changes in most parameters
are reflected on the servo amplifier and servomotor
operation immediately.
(2) Parameter page 2
On parameter page 2, parameters related to system setting
such as the homing functions are registered. Changes in
parameters become enabled after the power is turned off
then on again.
: Parameter page 1
: Parameter page 2
: Parameter page 3
PA01
PA02
PA03
PA01
ESC
SET
(1 sec. or over)
0
ESC
P
1
.
02
P1
.
01
SET
(1 sec. or over)
∧／∨
P
1
.
99
・・・
PA02
ESC
SET
(1 sec. or over)
0
ESC
P
2
.
02
P2
.
01
SET
(1 sec. or over)
∧／∨
P
2
.
99
・・・