CHAPTER 5 SERVO ADJUSTMENT
5-26
Profile Operation
5
In case of operation at keypad
With this method, profile operation is performed at the keypad.
For the detailed explanation of keypad, refer to "CHAPTER6 KEYPAD."
5.9.2 Description of Operation
Starting conditions
Conditions for starting profile operation are described. Necessary conditions are indicated with
"."
The operation does not start if the following conditions are not satisfied ("NG1" is indicated).
Operation is interrupted if any condition is dissatisfied during operation ("NG2" is indicated).
The gain reference value is left unchanged at the start level as far as resonance is not observed.
Power supply to
main circuit
No alarm state
BX signal turned
off
Neither ±OT nor
EMG
Operation pattern
The operation pattern is shown below. "P" in the table indicates the number of the basic
setting parameter (PA1_).
P21
Rotation speed
P21
P37
P22
P20
Time [s]
P38
P37
P38
Continue
P20
Fn13 Ptn
SET (1 sec. or over)
ESC
nG
_Ptn
8Ptn _StP
The lit arrow moves along a figure of
eight.
Operation stop
completion
SET (1 sec. or over)
ESC
ESC
ESC
SET (1 sec. or over)
During profile
operation
ESC
To Next Page
Loading...