CHAPTER 4 PARAMETER
4-94
Input Terminal Function Setting Parameter
4
4.6 Input Terminal Function Setting Parameter
Parameters marked "" in the "Power" field are enabled after the power is turned off then
turned on again. (Check that the display (7-segment display) on the servo amplifier is unlit
when the power is turned off.)
4.6.1 List (PA3_)
Control mode
No.
PA3_
Name Default value Power
Position Speed Torque
Record of
reference
value
01 CONT1 signal assignment
02 CONT2 signal assignment
03 CONT3 signal assignment
04 CONT4 signal assignment
05 CONT5 signal assignment
06 CONT6 signal assignment
07 CONT7 signal assignment
08 CONT8 signal assignment
09 CONT9 signal assignment
10 CONT10 signal assignment
11 CONT11 signal assignment
12 CONT12 signal assignment
13 CONT13 signal assignment
14 CONT14 signal assignment
15 CONT15 signal assignment
16 CONT16 signal assignment
17 CONT17 signal assignment
18 CONT18 signal assignment
19 CONT19 signal assignment
20 CONT20 signal assignment
21 CONT21 signal assignment
22 CONT22 signal assignment
23 CONT23 signal assignment
24 CONT24 signal assignment
Refer to the next
page.
26 CONT always ON 1 0
27 CONT always ON 2 0
28 CONT always ON 3 0
29 CONT always ON 4 0
To Next Page
Loading...