Fuji Electric ALPHA5 Smart - Description of each Parameter; PA3_51 to

CHAPTER 4 PARAMETER
4-102
Output Terminal Function Setting Parameter
4
Control mode
No.
PA3_
Name
Default
value
Power
Position Speed Torque
Record of
reference
value
93 Range1 of position: Setting2 0 -
○
- -
94 Range2 of position: Setting1 0 -
○
- -
95 Range2 of position: Setting2 0 -
○
- -
Paremeters marked "○" in the table are enabled in the corresponding control mode.
4.7.2 Description of Each Parameter
PA3_51 to 53 OUT 1 to 3 signal assignment (turned on/off by hardware OUT signal)
No. Name Setting range Default value Change
51 OUT1 signal assignment 1
52 OUT2 signal assignment 2
53 OUT3 signal assignment
Select among OUT
signal assignment
functions (refer to the
table on next page).
76
Power
PA3_56 to 71 (OUT6 to 21 signal assignment) can be set only by RS-485 communications.