Fuji Electric ALPHA5 Smart - Wizard Menu

CHAPTER 14 PC LOADER
Servo Operator 14-39
14
14.7.3 Wizard Menu
The Wizard Menu screen shown below appears when the PC loader for the ALPHA5 series is started.
 Monitor
The alarm history stored in the servo operator memory can be monitored.
 Edit parameters
Four parameters stored in the servo operator memory can be checked and edited.
In addition, new parameters can be registered to the servo operator memory.
 Edit positioning data
Two pieces of positioning data stored in the servo operator memory can be checked and edited.
In addition, new positioning data can be registered to the servo operator memory.
 Communications setup
The communications conditions between the servo operator and the PC can be set.
For the explanation of buttons on each screen, refer to the PC loader help.