Fuji Electric ALPHA5 Smart - Key; Blinking Display; Displaying Upper;Middle;Lower Data

CHAPTER 6 KEYPAD
Display 6-3
6
6.1.2 Key
 To show five or more digits, alternate the upper and lower four digits.
 To show nine or more digits, alternate the upper, middle and lower four digits sequentially.
6.1.3 Blinking Display
The keypad display blinks with some statuses.
The table below shows the statuses and contents regarding blinking display.
* When a parameter which becomes enabled after cycling the power is changed.
6.1.4 Displaying Upper/middle/lower Data
The display of the item described with is shown with upper/middle/lower digits.
Blinks three times: upper digits
Blinks three times: middle digits
Blinks three times: lower digits
* With some items the middle digit display is not used.
[MODE/ESC]
 The mode is switched (MODE).
 The mode is deselected (ESC).
[]
The sub mode is selected.
The value decreases by one (-1).
[]
The sub mode is selected.
The value increases by one (+1).
[SET/SHIFT]
 The cursor digit shifts to the right
(SHIFT).
 The mode or value settles (SET).
 Press and hold for at least one
second to settle.
----
----
----
U
L
／
Blink interval Duration Status How to recover
0.5 sec cycle Continuously Alarm Cycle the power or reset the alarm.
0.5 sec cycle 3 sec
Parameter being
confirmed
-
Once every 2 sec Continuously
During sequence test
mode
Cycle the power, or cycle the power
after changed to PA2_89 = 0.
Twice every 2 sec Continuously Cycle the power.* Cycle the power.