Fuji Electric ALPHA5 Smart - Page 322

CHAPTER 6 KEYPAD
6-10
Sequence Mode
6
Display
Control
mode
Name Description
Servo off
The motor is not turned on.
The servomotor has no driving force.
Servo on The servomotor is ready to rotate.
Manual operation Manual feed rotation state
Pulse operation During pulse input operation
Automatic
operation
Positioning is being executed.
Homing Homing is being executed.
Interrupt
positioning
Interrupt positioning is being executed.
+OT The positive over-travel signal is being detected.
-OT
The negative over-travel signal is being detected.
The display alternates between "P" and "-" .
Zero speed stop Stopped at zero speed due to forced stop signal
Position
control
In LV
In undervoltage. For details, see the pages about
undervoltage on page 7-10.
Servo off
The motor is not turned on.
The servomotor has no driving force.
Servo on The servomotor is ready to rotate.
Manual operation Manual feed rotation state
+OT The positive over-travel signal is being detected.
-OT
The negative over-travel signal is being detected.
The display alternates between "n" and "-" .
Zero speed stop Stopped at zero speed due to forced stop signal
Speed
control
In LV
In undervoltage. For details, see the pages about
undervoltage on page 7-10.
Servo off
The motor is not turned on.
The servomotor has no driving force.
Servo on The servomotor is ready to rotate.
Manual operation Manual feed rotation state
Torque
control
In LV
In undervoltage. For details, see the pages about
undervoltage on page 7-10.
~PoF
~pLu
~Pn0
Pot
Pot
_Pit
-Por
-PAt
_PPi
Pon
-
-
-PJG
~tLu
toF
ton
_tJG
-
-
-
-
-
-
-
-
-
-
noF
non
-nJG
not
not
~nn0
~nLu
-
-
-
-
-
-
-
-