CHAPTER 6 KEYPAD
Parameter Edit Mode 6-35
6
Value editing
When a parameter is loaded, the uppermost (leftmost) digit blinks. (If the parameter has the
upper/middle/lower-digit display, the uppermost detail is displayed.) The blinking digit can be
edited (the digit blinks at about 1-second intervals). Press the [] or [] key to change the value.
Even if "9" changes to "0," no carry-over occurs (the higher order number does not change).
Similarly, the higher order number does not change when "0" changes to "9."
Press the [SET/SHIFT] key to shift the digit to be edited. The digit shifts from 1 to 10 as shown
below, and returns to 1 after 10.
2890
2800
Press the [] key at the tens digit to increase "9."
The tens digit changes to "0" but no change occurs to the higher order
number.
99
----
9999
----
Blinks three times.
9999
----
Blinks three times.
Blinks three times.
SHIFT
SHIFT
① ②
③ ④ ⑤ ⑥
⑦ ⑧ ⑨ ⑩
To Next Page
Loading...