CHAPTER 14 PC LOADER
Installation Method 14-5
14
Message Manager (MM)
Message Manager (hereinafter referred to as "MM") controls the communications port when
multiple pieces of loader software run. It automatically runs after the ALPHA5 Series PC Loader is
launched. Keep MM running during operation of the ALPHA5 Series PC Loader.
If the PC Loader for the following Fuji Electric FA's products is used, the MM controlling the
communications function of the PC is launched in addition to the loader software of the
corresponding device. If the loader version of respective devices is old, the PC loader for the
ALPHA5 Series will not be enabled. In such a case, terminate the MM and then launch the PC
loader for the ALPHA5 Series.
If the ALPHA5 Series PC Loader is launched first, the PC Loader in the following list can be used.
Applicable
device
Applicable model Name and model of loader
SX Programmer Expert (D300winVer2)
/ NP4H-SEDBV2
SX Programmer Expert (D300winVer3)
/ NP4H-SEDBV3
SX Programmer Standard
/ NP4H-SWN
Fuji's integral
controller
MICREX-SX
SX communications middle ware
/ NP4N-MDLW
FRENIC-Mini
FRENIC-Eco
The FRENIC Loader
FRENIC-Multi FRENIC Loader
Fuji's inverter
FRENIC-MEGA FRENIC Loader 3
Look at the Windows task bar to check whether the MM runs or not.
Follow the procedure below to terminate MM (description is for the right handed mouse).
[1] Move the mouse cursor to the MM icon and click the right mouse button. "Exit Message Manager"
is displayed.
[2] Move the mouse cursor to "Exit Message Manager" and click the left mouse button. The
termination confirmation screen is displayed. Move the mouse cursor to "Yes" and click the left
mouse button.
[3] MM is terminated and the icon disappears from the task bar.
To Next Page
Loading...