Fuji Electric ALPHA5 Smart - Page 551

CHAPTER 14 PC LOADER
Communications Setting 14-7
14
2) When using the servo operator
 Wiring outline
 Setting method
(1) Select "Comm. Setup" from
Wizard Menu.
(2) Select "It communicates by way of servo
operator(USB)." in the Connected method
item, and then click the OK button.
 Notes
Set the same value between PA2_73 (communications baud rate) on the amplifier side and the
communications baud rate setting* on the servo operator side. (The initial value is 38400 bps for
both.)
No. Parameter name Setting range Default value Change
PA2_73
Communications
baud rate
0･･･ 38400 [bps]、1･･･ 19200 [bps]
2･･･ 9600 [bps]、3･･･115200 [bps]
0 Power
*) For the baud rate setting of the servo operator, refer to "Test Running " in the servo
operator manual.
PC Loader
CAT5 cable
(commercial item)
USB cable
(commercial item: B type or MiniB type)