CHAPTER 15 APPENDIXES
15-34
Replacement (from FALDIC-W)
15
GYG motor
The table below shows the cables and the connectors for the GYG motor and the servo amplifier.
Purchase Type
Motor power cable Existing item can be used. -
(1)
Motor power connector To be purchased. WSK-M03P-F
(2) Power supply connector To be purchased. WSK-S03P-F
(3) Sequence I/O cable Existing item can be used. -
(4) Encoder cable
Purchase the connector for the
amplifier side only.
WSK-P06P-M
(6) DC circuit connector Supplied with the amplifier. WSK-R05P-F
□□: cable length
Cable processing
molex
Connection with a GYG motor
(1) Motor power cable
Cut the amplifier-side connector part or the crimping terminal of the motor power cable, and then
connect it to the motor power connector for ALPHA5 Smart.
(2) Power supply cable
Cut the connector part of the power supply cable for FALDIC-W, and then connect it to the power
supply connector for ALPHA5 Smart.
(3) Sequence I/O cable
If the wiring of pulse is used with an open collector, be sure to cut the no. 7 pin (CA) and no.20 pin (CB)
on the amplifier-side connector.
Cut here.
Cut here.
servo amplifier (Frame2,3)
To Next Page
Loading...