D
IRECTION FR091521, REVISION 1 VIVID S60N/VIVID S70N BASIC SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-97
PRELIMINARY
8-5-4-5 BEP Installation Procedure
1) Carefully return the new BEP to the correct position in the cage assembly.
2) Check that the BEP is seated correctly then return and fasten the 5 screws (previously loosened)
to secure the BEP on the device’s chassis - refer to Figure 8-119 on page 8-96.
3.) Reinstall the Hard Disk:
4) Reconnect the BE-to-FEPS cable to the BEP - refer to Figure 8-118.
5.) Reconnect the HDR flat cable BE-to-CFE cable to the BEP.
6) Refit the following covers: front, DVD, right side, left side
7) Turn ON power to the system.
8.) Proceed to the instructions for performing a Vivid™ S60 or Vivid™ S70 software installation
procedure, commencing with step 11 on page 8-180.
• Hard Disk Installation Procedure on page 8 - 93
• Front Cover Installation Procedure on page 8 - 19
• DVD Cover Installation Procedure on page 8 - 12
• Right Side Cover Installation Procedure on page 8 - 10
• Air Inlet (Left Side) Cover Installation Procedure on page 8 - 8
To Next Page
Loading...
