D
IRECTION FR091521, REVISION 1 VIVID S60N/VIVID S70N BASIC SERVICE MANUAL
8-132 Section 8-5 - Electronic Cage Components - Replacement Procedures
PRELIMINARY
8-5-17-5 Fan (TRX32 Box) Installation Procedure
1) Position the new fan on the TRX32 Box cover then thread the fan cable through the top of the cover
and lead it through as shown in Figure 8-160 (right).
2) Using the rubber grommets provided, thread each rubber grommet from the inside of the TRX32
Box cover through to the new fan - Figure 8-160 (left) - and pull it through from side of the fan until
each grommet is firmly in position securing the fan - see Figure 8-159, above.
3.) Connect the fan cable to the CFE board - see Figure 8-160, above.
4.) Close the TRX32 Box cover and tighten the securing screws - see Figure 8-153 on page 8-127.
5) Return the Front End door assembly to the system, reconnect the cables (previously disconnected),
close the cabinet cage door and fasten securely with the two latches:
6) Refit the following covers: front, DVD, right side, left side
7.) Turn ON power to the system.
Figure 8-160 TRX32 Cover and Fan Cable
• Front End Door Assembly Closing and Installation Procedure on page 8 - 87
• Front Cover Installation Procedure on page 8 - 19
• DVD Cover Installation Procedure on page 8 - 12
• Right Side Cover Installation Procedure on page 8 - 10
• Air Inlet (Left Side) Cover Installation Procedure on page 8 - 8
To Next Page
Loading...
