Hioki IM3533 - Page 97

4.3 Setting DC Resistance Measurement
89
4
Chapter 4 LCR Function
Press .
2
Rdc Basic Settings
Press .
3
• When you want to limit the AUTO ranging range:
See "AUTO range limit function" (p. 90)
• If the instrument is being used outside the limits of
its specification, the suitable range may not be set
in auto ranging function. In this case, check the
accuracy assured ranges in "14.2 Measurement
Range and Accuracy" (p. 342) and then change
the test conditions.
Range Setting
4
Press to close the setting screen.