4. If no paper is loaded, the following message is displayed.
If the wrong type of paper is loaded, the following message is displayed.
If you choose to load the paper manually, follow the instructions on the front panel.
5. The printer starts to calibrate the Line Sensor. When the Line Sensor has been calibrated, the results are
displayed on the front panel. Press OK to continue or Cancel to exit.
If the values are not within the range specified, an error will appear on the front panel. In this case, try
the following.
●
Repeat the calibration.
●
Replace the Line Sensor
See Line Sensor Assembly on page 285.
ENWW Entering the Service Calibrations menu 121
To Next Page
Loading...