10. Remove the OMAS Sensor from the printer.
Installation
NOTE: To simplify the installation of the OMAS an Attachment Screw Retainer has been added to hold the
two T-20 attachment screws. This part is delivered attached to the replacement OMAS unit with the two
attachment screws. It is also delivered as a separate part with the Center Platen in case the OMAS is
completely removed during its replacement.
1. Check that the two T-20 attachment screws are correctly positioned in the Attachment Screw Retainer.
2. Position the OMAS under the printer and connect the large ribbon.
ENWW Disassembly order 343
To Next Page
Loading...