3. Lock the clips of the large ribbon cable connector.
4. Carefully push the OMAS fully up into its mounting so that the OMAS window protrudes slightly ABOVE
the Center Platen (approximately 0-2 mm). To ensure the OMAS is correctly positions, slide a sheet of
paper over the Platen Ribs until it is stopped by the OMAS. This ensures the OMAS is protruding slightly
above the platen.
CAUTION: Make sure the OMAS is pushed completely up into its mounting or you will encounter an
error during the OMAS calibration because it will not be able to focus on the paper.
5. Slide a sheet of paper over the OMAS window, if the paper is not stopped by the OMAS, repeat step 4 to
ensure the OMAS is pushed fully up into its the mounting.
344 Chapter 9 Printer part removal and installation ENWW
To Next Page
Loading...