6. Lock the clips of the large ribbon cable connector.
7. Carefully push the OMAS fully up into its mounting so it protrudes slightly (approximately 0.1 mm)
above the Center Platen. To ensure the OMAS is correctly positions, slide a sheet of paper over the
Platen Ribs until it is stopped by the OMAS. This ensures the OMAS is protruding slightly above the
platen.
CAUTION: Make sure the OMAS is pushed completely up into its mounting or you will encounter an
error during the OMAS calibration because it will not be able to focus on the paper.
8. If the paper is not stopped by the OMAS, repeat step 4 to ensure the OMAS is push fully up into its the
mounting.
384 Chapter 9 Printer part removal and installation ENWW
To Next Page
Loading...