Huawei Quidway S3900 Series - Page 713

Operation Manual – Mirroring
Quidway S3900 Series Ethernet Switches Chapter 1 Mirroring Configuration
Huawei Technologies Proprietary
1-9
 Note:
z Configurations listed in Table 1-6 do not involve specifying a mirroring group.
Therefore these mirroring settings made in Ethernet port view applies to mirroring
group 1 only.
z Configurations listed in Table 1-7 can be used to add mirroring settings for any
defined mirroring group in Ethernet port view.
z Configurations listed in Table 1-8 should to be performed in system view. Therefore
the mirroring group ID and port number need to be specified.
Caution:
To ensure correct port mirroring performance, you are not recommended to configure
the monitor port and mirroring port in the same VLAN.
IV. Configuration Example
z The source port is GigabitEthernet 1/1/1. Mirror all packets received and sent via
this port.
z The destination port is GigabitEthernet 1/1/4.
1) Configuration procedure 1:
<Quidway> system-view
[Quidway] mirroring-group 1 local
[Quidway] interface gigabitEthernet 1/1/4
[Quidway-GigabitEthernet1/1/4] monitor-port
[Quidway-GigabitEthernet1/1/4] quit
[Quidway] interface gigabitEthernet 1/1/1
[Quidway-GigabitEthernet1/1/1] mirroring-port both
2) Configuration procedure 2:
<Quidway> system-view
[Quidway] mirroring-group 1 local
[Quidway] interface GigabitEthernet 1/1/4
[Quidway-GigabitEthernet1/1/4] mirroring-group 1 monitor-port
[Quidway-GigabitEthernet1/1/4] quit
[Quidway] interface GigabitEthernet 1/1/1
[Quidway-GigabitEthernet1/1/1] mirroring-group 1 mirroring-port both
3) Configuration procedure 3:
<Quidway> system-view
[Quidway] mirroring-group 1 local
[Quidway] mirroring-group 1 monitor-port GigabitEthernet 1/1/4
[Quidway] mirroring-group 1 mirroring-port GigabitEthernet 1/1/1 both