Operation Manual – Voice VLAN
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 1
Voice VLAN Configuration
Huawei Technologies Proprietary
1-5
Operation Command Description
Enable the voice
VLAN security
mode
voice vlan security enable
Optional
By default, the voice VLAN
security mode is enabled.
Set the aging time
for the voice VLAN
voice vlan aging minutes
Optional
The default aging time is
1,440 minutes.
Enable the voice
VLAN function
globally
voice vlan vlan-id enable
Required
Caution:
z You cannot add an Access port to a voice VLAN which is in the automatic mode.
Therefore,voice VLAN function and VLAN VPN function must not be configured
simultaneously.
z Voice VLAN in automatic mode only supports the Hybrid port to process the tagged
voice stream, while the protocol VLAN function requires the Hybrid port to untag the
packets (refer to the VLAN part of the manual for detail), therefore, you must not
configure a VLAN as both a voice VLAN and a protocol VLAN.
z You cannot configure the default VLAN as a voice VLAN for a port working in the
automatic mode. Otherwise, the system will prompt that you cannot perform the
configuration.
Note:
When the voice VLAN is working normally, if it meets such situations as the restart of
devices or the change of Unit ID of a device in a stack, in order to make the established
voice connections work normally, the system does not need to be triggered by the voice
stream again to add the port configured as automatic mode to the local devices and
stack the voice VLAN globally but does so immediately after the completion of the
restart or the changes of Unit ID.
1.2.3 Configuring a voice VLAN to operate in manual mode
Table 1-4 Configure a voice VLAN to operate in manual mode
Operation Command Description
Enter system view
system-view
—
To Next Page
Loading...
