Operation Manual – Auto Detect
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 2
Auto Detect Implementation
Huawei Technologies Proprietary
2-6
Table auto det or VLAN interface 2-3 Configure the ect function f backup
Operation Command Description
Enter system view
iew
—
system-v
Enter VLAN
interface view
interface vlan-interface
vlan_id
—
Enable the auto
detect function to
implement VLAN
interface backup
standby detect-group
group-number
This operation is only
needed on the secondary
VLAN interface.
Required
2.4.2 Configuration Example
I. Netw
z
z
z
utes between Switch A, Switch B, and Switch C are reachable;
and those between Switch A, Switch D, and Switch C are also reachable.
II. Network diagram
ork requirements
z Configure a static route between Switch C and Switch A.
Create detecting group 10 on Switch A to detect the connectivity between Switch
B and Switch C.
Configure VLAN 1 interface to be the primary interface, which is enabled when
the result of detecting group 10 is reachable.
Configure VLAN 2 interface to be the secondary interface, which is enabled
when the result of the detecting group is unreachable.
z Make sure the ro
192.168.1.2
192.168.2.2 20.1.1.2
10.1.1.3
Switch A
Switch B
Switch C
Switch D
192.168.1.2/24
192.168.2.2/24 20.1.1.3/24
10.1.1.3/24
10.1.1.4/24
Switch A
Switch B
Switch D
20.1.1.4/24
192.168.1.2
192.168.2.2 20.1.1.2
10.1.1.3
Switch A
Switch B
Switch D
192.168.1.2/24
192.168.2.2/24 20.1.1.3/24
10.1.1.3/24
Switch A
Switch B
Switch D
20.1.1.4/24
192.168.1.2
192.168.2.2 20.1.1.2
10.1.1.3
Switch A
Switch B
Switch C
Switch D
192.168.1.2/24
192.168.2.2/24 20.1.1.3/24
10.1.1.3/24
Switch A
Switch B
Switch D
20.1.1.4/24
192.168.1.2
192.168.2.2 20.1.1.2
10.1.1.3
Switch A
Switch B
Switch D
192.168.1.2/24
10.1.1.3/24
192.168.2.2/24 20.1.1.3/24
Switch B
Switch A
Switch D
20.1.1.4/24
VLAN 2
192.16 8.2.1 /24
GE1/0/2
VLAN 2
192.16 8.1.1 /24
GE1/0/1
VLAN 1
r VLAN interface backup
II edure
Figure 2-3 Network diagram fo
I. Configuration proc
z Configure Switch C.
To Next Page
Loading...
