Operation Manual – Auto Detect
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 2
Auto Detect Implementation
Huawei Technologies Proprietary
2-7
s the primary route, with
1.1.3
as the secondary route,
.1.3/24 as the next hop.
-static 192.168.2.1 24 20.1.1.3
rface1] ip address 192.168.1.1 24
/2
interface 2
p address 192.168.2.1 24
ss of 10.1.1.4 to detecting group 10 to detect the reachability of the
1.
t-list 1 ip address 10.1.1.4 nexthop
ect-group-10] quit
en the result of detecting group 10 is
[QuidwayA] interface vlan-interface 2
[QuidwayA-Vlan-interface2] standby detect-group 10
# Enter system view.
<QuidwayC> system-view
# Configure a static route to VLAN interface 1 on Switch A a
the IP address of 10.1.1.3/24 as the next hop.
[QuidwayC] ip route-static 192.168.1.1 24 10.
# Configure a static route to VLAN interface 2 on Switch A
with the IP address of 20.1
[QuidwayC] ip route
z Configure Switch A.
# Enter system view.
<QuidwayA> system-view
# Assign an IP address to VLAN 1 interface.
[QuidwayA] interface vlan-interface 1
[QuidwayA-Vlan-inte
# Add port GigabitEthernet1/0/2 to VLAN 2.
[QuidwayA] vlan 2
[QuidwayA-vlan2] port GigabitEthernet1/0
[QuidwayA-vlan2] quit
# Assign an IP address to VLAN 2 interface.
[QuidwayA] interface vlan-
[QuidwayA-Vlan-interface2] i
# Create detecting group 10.
[QuidwayA] detect-group 10
# Add the IP addre
IP address, with the IP address of 192.168.1.2/24 as the next hop, and the detecting
number set to
[QuidwayA-detect-group-10] detec
192.168.1.2
[QuidwayA-det
# Specify to enable VLAN 2 interface wh
unreachable.
To Next Page
Loading...
