Operation Manual – Routing Protocol
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 5 BGP Configuration
Huawei Technologies Proprietary
5-35
Caution:
z Normally, full connection is not required between an RR and a client. A route is
reflected by an RR from a client to another client. If an RR and a client are fully
connected, you can disable the reflection between clients to reduce the cost.
z Normally, there is only one RR in a cluster. In this case, the router ID of the RR is
used to identify the cluster. Configuring multiple RRs can improve the network
stability. If there are multiple RRs in a cluster, use related command to configure the
same cluster ID for them to avoid routing loopback.
5.7.5 Configuring BGP Confederation
Table 5-18 Configure BGP confederation
Operation Command Description
Enter system view
system-view
—
Enable BGP, and enter BGP
view
bgp as-number
Required
By default, the system
does not operate BGP.
Configure
confederation
ID
confederation id
as-number
Basic BGP
confederation
configuration
Specify the
sub-ASs
included in a
confederation
confederation
peer-as
as-number-list
Required
By default, no
confederation ID is
configured and no sub-AS
is configured for a
confederation.
Configure the compatibility of a
confederation
confederation
nonstandard
Optional
By default, the
confederation configured is
consistent with the
RFC3065.
To Next Page
Loading...
