Huawei Quidway S5600 Series - Page 379

Operation Manual – Routing Protocol
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 5 BGP Configuration
Huawei Technologies Proprietary
5-34
Operation Command Description
Configure the peers to
advertise community attribute
to each other
peer group-name
advertise-commu
nity
Required
By default, no community
attribute or extended
community attribute is
advertised to any peer
group.
Specify routing policy for the
routes exported to the peer
group
peer group-name
route-policy
route-policy-name
export
Required
By default, no routing
policy is specified for the
routes exported to the peer
group.
Caution:
z When configuring BGP community, you must use a routing policy to define the
specific community attribute, and then apply the routing policy when a peer sends
routing information.
z For configuration of routing policy, refer to “IP Routing Policy Configuration”.
5.7.4 Configuring BGP RR
Table 5-17 Configure BGP RR
Operation Command Description
Enter system view
system-view
-
Enable BGP, and enter BGP
view
bgp as-number
Required
By default, the system
does not operate BGP.
Configure the local router as
the RR and configure the peer
group as the client of the RR
peer group-name
reflect-client
Required
By default, no RR and its
client is configured.
Enable route reflection
between clients
reflect
between-clients
Optional
By default, route reflection
is enabled between clients.
Configure cluster ID of an RR
reflector cluster-id
cluster-id
Optional
By default, an RR uses its
own router ID as the cluster
ID.