Huawei Quidway S5600 Series - Page 643

Operation Manual - DHCP
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 2
DHCP Server Configuration
Huawei Technologies Proprietary
2-13
monitor network devices that dynamically obtain IP addresses universally and
effectively.
After configuring the connection between the DHCP global address pool and the BIMS
server, you can enable the BIMS server to manage the devices that have obtained IP
addresses from the global address pool.
Table 2-10 Configure connection between a DHCP global address pool and a BIMS
server
Operation Command Description
Enter system view
system-view
-
Create a DHCP address
pool and enter DHCP
address pool view
dhcp server ip-pool
pool-name
Required
By default, no DHCP global
address pool is created
Configure the
connection between the
DHCP global address
pool and the BIMS
server
bims-server ip
ip-address [ port
port-number ] sharekey
key
Required
By default, no connection
between the DHCP global
address pool and the BIMS
server is configured
2.3 Interface Address Pool-based DHCP Server
Configuration
Caution:
In the interface address pool mode, after the addresses in the interface address pool
have been assigned, the DHCP server picks IP addresses from the global interface
address pool containing the segment of the interface address pool and assigns them
to the DHCP clients. As a result, the IP addresses obtained from global address pools
and those obtained from interface address pools are not in the same network segment,
so the clients cannot interoperate with each other.
In the interface address pool mode, if the IP addresses in the same address pool are
required to be assigned to the clients on the same VLAN interface, the number of
clients that obtain IP addresses automatically cannot exceed the number of the IP
addresses that can be assigned in the interface address pool.