Operation Manual - DHCP
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 2
DHCP Server Configuration
Huawei Technologies Proprietary
2-14
2.3.1 Configuration Overview
An interface address pool is created when the interface is assigned a valid unicast IP
address and you execute the dhcp select interface command in interface view. The
IP addresses contained in it belong to the network segment where the interface
resides in and are available to the interface only.
You can perform certain configurations for DHCP address pools of an interface or
multiple interfaces within specified interface ranges. Configuring for multiple interfaces
eases configuration work load and makes you to configure in a more convenient way.
Table 2-11 Overview of interface address pool-based DHCP server configuration
Configuration task Remarks Section
Enable DHCP Required 2.3.2 ”Enabling DHCP”
Configure to assign the IP
addresses of the local
interface-based address pools
to DHCP clients
Required
2.3.3 “Configuring to
Assign the IP Addresses
of Interface Address Pools
to DHCP Clients
”
Configure to
bind IP address
statically to
DHCP clients
Configure
to assign IP
addresses
of interface
DHCP
address
pool to
DHCP
clients
Configure to
assign IP
addresses
dynamically
One among these
two options is
required. These two
options can be
configured at the
same time.
2.3.4 “Configuring to
Assign IP Addresses of
DHCP Address Pools to
DHCP Clients
”
Configure DNS service for the
DHCP server
Optional
2.3.5 “Configuring DNS
Services for the DHCP
Server
”
Configure NetBIOS service for
the DHCP server
Optional
2.3.6 “Configuring
NetBIOS Services for
DHCP Clients
”
Customize DHCP service Optional
2.3.7 “Customizing
DHCP Service
”
To Next Page
Loading...
