Huawei Quidway S5600 Series - Page 645

Operation Manual - DHCP
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 2
DHCP Server Configuration
Huawei Technologies Proprietary
2-15
Configuration task Remarks Section
Configure the connection
between the DHCP interface
address pool and the BIMS
server
Optional
2.3.8 ”Configure
Connection Between the
DHCP Interface Address
Pool and the BIMS
Server
”
2.3.2 Enabling DHCP
You need to enable DHCP before performing DHCP configurations. DHCP-related
configurations are valid only when DHCP is enabled.
Table 2-12 Enable DHCP
Operation Command Description
Enter system view
system-view
—
Enable DHCP
dhcp enable
Required
By default, DHCP is enabled
2.3.3 Configuring to Assign the IP Addresses of Interface Address Pools to
DHCP Clients
If the DHCP server works in the interface address pool mode, it picks IP addresses
from the interface address pools and assigns them to the DHCP clients. If there is no
available IP address in the interface address pools, the DHCP server picks IP
addresses from its global address pool that contains the interface address pool
segment and assigns them to the DHCP clients.
Table 2-13 Configure to assign the IP addresses of interface address pools to DHCP
clients
Operation Command Description
Enter system view
system-view
—
interface interface-type
interface-number
dhcp select interface
Configure to
assign the IP
addresses of
interface
address pools
Configure
the current
interface
quit
Required
By default, a DHCP
server assigns the
IP addresses of the
global address pool