Huawei Quidway S5600 Series - Page 899

Operation Manual – FTP and TFTP
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 1 FTP and TFTP Configuration
Huawei Technologies Proprietary
1-6
Operation Command Description
Display the source IP
address set for an FTP
server
display ftp-server
source-ip
Display the login FTP
clients on an FTP server
display ftp-user
1.1.3 Configuration Example: A Switch Operating as an FTP Server
I. Network requirements
A switch operates as an FTP server and a remote PC as an FTP client.
z Create a user account on the FTP server with the user name “switch” and
password “hello”.
z Configure the IP address 1.1.1.1 for a VLAN interface on the switch, and 2.2.2.2
for the PC. Ensure the route between the two is reachable.
The switch application named switch.bin is stored on the PC. Upload it to the FTP
server through FTP to upgrade the application of the switch, and download the switch
configuration file named vrpcfg.cfg from the switch to backup the configuration file.
II. Network diagram
Switch
PC
Network
Network
Switch
PC
Network
Network
Figure 1-2 Network diagram for FTP configurations
III. Configuration procedure
1) Configure the switch
# Log into the switch. (You can log into a switch through the Console port or by
Telneting to the switch. See the “Login” module for detailed information.)
<Quidway>
# Start the FTP service on the switch and create a user account and the
corresponding password.
<Quidway> system-view
[Quidway] ftp server enable