Huawei Quidway S5600 Series - Page 921

Operation Manual – Information Center
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 1
Information Cente
r
Huawei Technologies Proprietary
1-9
Operation Command Description
Define an
information source
info-center source
{ modu-name | default }
channel { channel-number |
channel-name } [ { log | trap
| debug } { level severity |
state state } ]*
Required
Set the format of
time stamp
info-center timestamp
{ log | trap | debugging }
{ boot | date | none }
Optional
To view debugging/log/trap output information on the console, you should also enable
the corresponding debugging/log/trap information terminal display on the switch.
For example, to view log information of the switch on the console, you should not only
enable log information output to the console, but also enable log information terminal
display with the terminal logging command.
Perform the following operations in user view.
Table 1-7 Enable debugging/log/trap terminal display
Operation Command Description
Enable the
debugging/log/trap
information
terminal display
function
terminal monitor
Optional
By default, this function is
enabled for console user.
Enable debugging
information
terminal display
function
terminal debugging
Optional
By default, the debugging
information terminal display is
disabled for terminal users.
Enable log
information
terminal display
function
terminal logging
Optional
By default, log information
terminal display is enabled for
console users.
Enable trap
information
terminal display
function
terminal trapping
Optional
By default, trap information
terminal display is enabled for
terminal users.