Huawei Quidway S5600 Series User Manual

Operation Manual – Information Center
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 1
Information Cente
r
Huawei Technologies Proprietary
1-10
1.2.4 Enabling Information Output to a Monitor Terminal
Table 1-8 lists the related configurations on the switch.
Table 1-8 Enable information output to a monitor terminal
Operation Command Description
Enter system view
system-view
—
Enable the
information center
info-center enable
Optional
By default, the information
center is enabled.
Enable information
output to Telnet
terminal or dumb
terminal
info-center monitor
channel { channel-number |
channel-name }
Required
By default, a switch outputs
log/debugging/trap
information to user terminal
through information channel
1.
Define an
information source
info-center source
{ modu-name | default }
channel { channel-number |
channel-name } [ { log | trap
| debug } { level severity |
state state } ]*
Required
Set the format of
time stamp
info-center timestamp
{ log | trap | debugging }
{ boot | date | none }
Optional
This is to set the time stamp
format for log/debugging/trap
information output.
This determines how the time
stamp is presented to users.
 Note:
z When there are multiple Telnet users or dumb terminal users, some configuration
parameters (including module filter, language and severity level threshold settings)
are shared between them. In this case, change to any such parameter made by one
user will also be reflected on all other user terminals.
z To view debugging information of specific modules, you need to set the information
type as debug when defining the information source, and enable debugging for
corresponding modules through the debugging command as well.
To view the debugging/log/trap output information on the monitor terminal, you should
enable the corresponding debugging/log/trap display function on the switch.

Huawei Quidway S5600 Series Specifications

General

Brand	Huawei
Model	Quidway S5600 Series
Category	Switch
Language	English