Operation Manual – System Maintenance and Debugging
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 1
BootROM and Host Software Loading
Huawei Technologies Proprietary
1-6
Step 5: Click the <Disconnect> button to disconnect the HyperTerminal from the switch
and then click the <Connect> button to reconnect the HyperTerminal to the switch, as
shown in
Figure 1-3.
Figure 1-3 Connect and disconnect buttons
Note:
The new baud rate takes effect only after you disconnect and reconnect the
HyperTerminal program.
Step 6: Press <Enter> to start downloading the program. The system displays the
following information:
Now please start transfer file with XMODEM protocol.
If you want to exit, Press <Ctrl+X>.
Loading ...CCCCCCCCCC
Step 7: Choose [Transfer/Send File] in the HyperTerminal’s window, and click
<Browse> in pop-up dialog box, as shown in
Figure 1-4. Select the software you need
to download, and set the protocol to XMODEM.
Figure 1-4 Send file dialog box
Step 8: Click <Send>. The system displays the page, as shown in
Figure 1-5.
To Next Page
Loading...
