Hurco winmax - Page 288

X - Index v546CO WinMax Lathe Conversational Part Programming
Comment block 2 - 201
Draw console key 1-7
Drill 2-58
Drilling Operation, live-tooling 2 - 119
dwell 2-63
DWELL (SECS) field
Cutoff block 2-64
Position block 2-7
Dwell drilling 2-59
DWELL field
Axial Holes Drill Operation screen 2-
180
Cutoff Block Advanced Pecking tab 2-
65
Machine Function (M Code) screen 2-
198
Radial Holes Drill Operation screen 2-
117
Transfer block screen 2 - 209
Dwell peck type, Cutoff 2-63
DWELL TIME (SEC) field
Axial Holes Drill Operation screen 2-
180, 2-181, 2 - 182
Hole cycle 2-60
Radial Holes Drill Operation screen 2-
119, 2-120
E
editing 1-7
element 2-25
definition 2-11
Element operations
arc 2-26
blend arc 2-26
chamfer 2-26
face 2-26
taper 2-26
turn 2-26
ELEMENT TOLERANCE field
Profile Start screen 2-16, 2-20, 2-
21, 2-23
Emergency Stop -viii
ENABLE BLEND MOVES field
Axial Mill Contour screen 2-130
Radial Mill Contour screen 2-73
ENCOMPASS field
Axial Mill Flats screen
Polar Coordinates 2 - 171
Rectangular Coordinates 2-173
END CAP field
Axial Mill Slot screen
Polar Coordinates 2 - 164
Rectangular Coordinates 2-166
Radial Slot screen
Linear Coordinates 2-109
Rotary Coordinates 2 - 106
End console key
use with Program Review screen 1-9
error messages -vii
F
Face 2-26
FACE ALLOWANCE field
Finishing 2-53
Profile Start screen 2-25
FACE CLEARANCE field
Axial Mill Flats screen 2 - 170
Face Element 2-29
FACE F1 softkey, element 2-26
Face thread 2-40
Face Thread Type 2-49
FEED (IPM) field 2-7
FEED field
Axial Mill Contour Arc Segment screen
Polar Coordinates 2 - 140
Rectangular Coordinates 2-141
Axial Mill Contour Blend Arc segment
Polar Coordinates 2 - 143
Rectangular Coordinates 2-144
Axial Mill Contour Line Segment screen
Polar Coordinates 2 - 136
Rectangular Coordinates 2-137
Cutoff block 2-63
Cutoff Block Advanced Pecking tab 2-
65
Grooving 2-52
Move Tailstock screen 2 - 206
Profile Start screen 2-12
Radial Mill Contour Arc Segment screen
Linear Coordinates 2-84
Rotary Coordinates 2-83
Radial Mill Contour Blend Arc Segment
screen
Linear Coordinates 2-87
Rotary Coordinates 2-86
Radial Mill Contour Line Segment
screen
Linear Coordinates 2-80
Rotary Coordinates 2-79
Transfer block screen 2 - 208, 2-209
FEED OVERRIDE LOCKOUT field, Change
Parameters 2-193
Feed per Minute (FPM) 1-3
FEED PER MINUTE F4 softkey
Cutoff block 2-64
FEED PER REV F5 softkey
Cutoff block 2-64
Feed per Revolution 1-3